Recherche Designation Sur Un Voyant De Tableau De Bord E46

[timor22]

bonjour

j'ai un voyant rond qui s'allume avec un point d'exclamation a l'interieur
ce rond est dentelé et s'allume a coté du D de la boite auto au tableau de bord

est ce que quelqu'un sait ce que ca signifie?

Merci d'avance

[330ci_78]

Probleme de transmission automatique.
Mode protection.
Si le defaut persiste et le voyant ne s'eteint pas, passage obligé chez BMW.
La boite ne fonctionne plus qu'en 3 et 4.

Dans le carnet de la voiture, tout est expliqué; page 75

[abyss]

Ta pas le manuel d'utiliation ?

Voila une copie mais en anglais :



Page 73 :

Automatic transmission*
Electronic transmission control
module
If the indicator lamp comes on
or if the message "TRANS.
FAILSAFE PROG" appears in
the Check Control*, there is a malfunction
in the transmission system.
Bring the vehicle to a stop, select the
"Park" position, apply the parking brake
and shut the engine off (ignition key position
0). Restart the engine after a few
seconds. If the indicator lamp goes out
again after a few seconds, the normal
transmission functions have been restored.
You may continue to drive as
usual.
If the indicator lamp does not go out,
you can place the selector lever in all
positions. However, the vehicle will now
only drive forward with limited gear
selection.
Under these circumstances, avoid extreme
engine loads and consult the
nearest authorized BMW center.
Do not work in the engine compartment
when a drive gear (forward
or reverse) is engaged. If you do
this, the vehicle could move.<
For jump-starting, towing and towstarting,
refer to pages 182 and 183.

page 76

Electronic transmission control
module
If the indicator lamp comes on
or the message "TRANS.FAILSAFE
PROG" appears in the
Check Control*, there is a fault in the
transmission system.
Bring the vehicle to a stop. Move the
transmission selector lever to "P." Set
the parking brake and turn the engine
off (ignition key to position 0).
Wait a few seconds, then start the
engine.
If the indicator lamp goes out after a
few seconds, normal transmission performance
has been restored. You may
continue to drive as usual. If the indicator
lamp does not go out, you can place
the selector lever in all positions. However,
the vehicle will now only drive forward
with limited gear selection.
If this happens, avoid extreme engine
loads and consult the nearest authorized
BMW center.